Changed a size to fit my vent
Printed with Bambu PETG in white and red. I have demolished quite a few PLA printed scrapers, so figured I would try this one in PETG to see if it lasts longer ;)
Fun little scraper. I like its small size and ease of use. Printed in two colors to highlight the Bambu Labs Logo. Fun!
Simple but works! Printed in PETG which should handle up to around 70C. I don't think I have seen the chamber get about around 50ish even when printing PC. Or at least I don't remember seeing higher temps than that. I think PETG will be OK but if turns out not to be, I'll reprint in PC or ASA. Thanks! (edited)
Printed in ASA as I've no idea how hot the enclosed chamber gets. Model fits well into the moulded recesses and feels solid once installed.
View 2 more comments
@reedx_90905 look at the remix i made ( https://www.printables.com/de/model/543574-ventilation-with-fan-mounts) this one is very handy, i always have the door and lid closed (the intended vents too, I'm thinking about another remix) but the fans on and it is always max 32°C inside the chamber. And if I want to print ASA or PC i just turn off the fans and close it with the covers. Got 58°C (Bambu thermometer) inside the chamber.
@JermaineT_Mehrlich Great job!
Orient the same way as in 0 degrees rotated from the way they are printed? 180 degrees? or mirrored l-to-r before printing is OK?
@layerworks orient the same way as in all have to be rotated or mirrored equally or else the pattern won't be as effective in diffusing the sound. (edited)