Herome design recently came out with gantry adapter for kp3s 3.0 so far I am liking it, but I also a little iffy because the metal bracket for the titan extruder is not used with hero me. But I am honestly liking this setup since I can use that metal bracket and make the hotend feel more secured. Is the part cooling duct adjustable? Clone V6 I have are significantly shorter than the stock hotend that comes with it.
Hi, is there a place to mount a BL-Touch on this?
View one more comment
@Dinol I can send you one, if you are interested. Strangely enough, i found a source for the original Antclabs BL-Touch (not the fake 3d-touch) for around 14€, i bought three, but i only need two.
@Tecneeq_33029 Sure I'm interested however I am located in the U.S. We can discuss this more through private PMs, just send a message over.
Atomic Filament Gun Metal Gray
Fit together well. Had no issues with any of the cables fitting.
Is the V3 killswitch-compatible design still being worked on?
Wonderful design. Printed with a mesh as suggested by the designer for both the top and bottom in PLA.
Used supports and brim. Fits the anker perfectly in place. I tried to put a rubber texture beneath the Deck, but doesn't quite fit. I also didn't have m2 6mm screws - shaved down m2 8mm to make them fit. (edited)
great fit!
Great idea!