hi. i was wondering, is it possible to make this so it also fits the gridfinity system by adding those squares underneath it so itll fit into the gridfinity baseplates?
Printed really well and does the job. I wish the viewfinder cover sat closer to the camera but then you would need support. Great model.
Exactly what I needed to learn well how to use sandstone ! I printed it with a 0.1 mm layer height as recommended, I sanded it and varnished it to protect it from water. Thank you for sharing your design !
Works as it should. I use it to touch up my SAKs on a whetstone. The angles are 100% accurate. I threw some rubber pads on mine to give more grip and make a gap between the angle and the stone. Printed in PETG @ 0.1mm. (edited)
One of the best cases I have seen great fit.You should make a stackable version!
Not pictured here but the fit is snug. Overall quite a nifty model.