Could you post the step file of this? I am working on a design update on my printer where I will mount a canbus board on the side of the lgxlite. Could use yours as a base to add the bracket and integrated cover.

Just what I needed to add beacon to the 3.1.

Made the holes fo the Beacon mount heat inserts a bit smaller ... Never the less nice model! Thanks for the remix!

Do you happen to have any insight as to why I am having issues getting a response from the Z motors? I just klipperized my V3 120z and inputs the very last part of my systems check before running the first homing sequence (stepper_buzz command) I am getting the expected response from the x and y motors but get an mcu shut down when I run it on the z. Any insight would be greatly appreciated. Thank you.

Just a raw print to testfit the parts.

Hello, great project! Did you managed to adapt the new board at the same spot? Did you use the original power supply? Can you tell me more about the hardware mods? I have a stock um2 with Klipper and a glued raspberry pi ate the bottom, but the original hotend project has some age, with a low flow (for nowadays standard). (edited)

Can you make one for 2020

I cant even get the file to load.. can you re-upload?