The design shows some weird artifacts on the bottom side, not being completelly flat, although they do not seem to be too problematic. Also, the material in between the magsafe cutout and the cameras looks so thin that probably can lead to some issues. Apart from that looks good therefore I'll definitelly give it a try and let you know if I'm succesfull in using TPU for this one, Thanks a lot for bringing it over here! Kind regard (edited)
@EduardoCid_468294 The thin part looks delicate but it isn't (fortunately!). It needed to be that thin so that my cooler would fit... agreed it's not ideal. The other thing is a surprise to me, didn't notice it and just figured my own print had some imperfections in that spot. Not sure what could've caused it, but Tinkercad isn't exactly a professional software, so maybe a glitch?
The design shows some weird artifacts on the bottom side, not being completelly flat, although they do not seem to be too problematic. Also, the material in between the magsafe cutout and the cameras looks so thin that probably can lead to some issues. Apart from that looks good therefore I'll definitelly give it a try and let you know if I'm succesfull in using TPU for this one, Thanks a lot for bringing it over here! Kind regard (edited)
@EduardoCid_468294 The thin part looks delicate but it isn't (fortunately!). It needed to be that thin so that my cooler would fit... agreed it's not ideal. The other thing is a surprise to me, didn't notice it and just figured my own print had some imperfections in that spot. Not sure what could've caused it, but Tinkercad isn't exactly a professional software, so maybe a glitch?
Let's go for it! (edited)