Eufy Indoor S350 Wall Mount TD Remix

The wall mount that comes with S350 is horrible as the original creator said. I totally agree with him, that the angel is no good at all with it. I did some changes on Terrys model, so it fitted my needs.

This is my very first remix that I have done and also uploaded it. 
I'm still learning the functions in Fusion 360 and trying creating models. 

Big credit to Terry for creating the original model.

I printed it on my Snapmaker A350 with PLA and settings for strong build. 
It took around 7-8h for that to print it.
 
For the screws, nuts and bricks, I use M4. The lenght of the M4 screws are 25mm, as they where only I had at home. I think 18mm-20mm is a better choice, but 25mm works fine too. 

To the wall I will use the original screws, that was included with the S350 Camera.

I adjusted the mounting holes for the wall, so they are matching the holes on the S350 original mount.
Perfectly when you already drilled the holes in the wall for the S350 original mount.
I removed both anchors and added two holes that is matching the original mount. So you can screw the original mount in place with 2 screws, 2 nuts and 2 bricks.