Voron v2.4 - Gantry Installation Hook (new Version!!)

This is a hook for installing the gantry on a voron 2.4. It helps hanging up the gentry to the frame. Update!!
88
748
8
3114
zaktualizowano 25 stycznia 2024

Opis

PDF

This is a gantry installation hook for voron 2.4. It fits to 2020 extrusions and helps lifting up the gantry to the frame easy. The hook is 12cm long. The lower part is 6mm thick and fits into the extrusion. The upper part has a 2cm wide hook which fits to the 2020 extrusion of the frame.

Just hook in the gantry on left and right side, lift it up and hook the upper part to the frame. Then just add the other hooks as shown in the picture.

For version 2 (v2) needed (per hook):

  • M3x8 screw
  • M3 nut

 

Obsolete!! Update on removing the hooks: It is a bit hard to remove them. I could just raise the gentry with the belts a little bit and get the upper part back over the extrusion. The gantry should stay in position with the belts after this. Then I lowered the gantry a little bit by moving the belts and could remove the hooks completely. When I get the time, I will redesign them a little bit. for better removal. 

 

Update 02/2023

I modified the hook. It is split into 2 parts now which can be screwed together with a M3x8 cylinder head screw (or longer) and a M3 nut. This should be much easier to disassemble after gantry installation.

Note I did not test the new version (as I have no need for it now). But I think the still should work fine! Please let me know!!

 

My Voron Mod Repo: https://github.com/andimoto/voronmods.git

 

Tagi



Pochodzenie modelu

Autor oznaczył ten model jako własne oryginalne dzieło.

Licencja