ZK-4KX Power Supply Case

A basic yet functional case for a power supply module. It can be easily printed. 

Similar modules should be compatible with them too, but I have tested only this one. To assemble the case, you need a drop or two of glue. You may need to trim the inner sides a bit.

One of the pieces need to be printed with supports. Layer height is up to you. 

Parts via aliexpress:

ZK-4KX: https://www.aliexpress.com/item/4000766900344.html

Banana terminals: https://www.aliexpress.com/item/32721475121.html

DC Jack terminal: https://www.aliexpress.com/item/32837700581.html

In addition, you can add some rubber legs to prevent it from slipping.

If you have any questions, you can ask in the comments or message me. If you like this item, you can leave feedback :)