Metric Nut-Driver Holder

Holder for the DYN DYN2806 Dynamite 5 pc Metric Nut Driver Assortment you can get on Amazon. I found a few different…
13
39
0
311
updated November 17, 2021

Description

PDF

Holder for the DYN DYN2806 Dynamite 5 pc Metric Nut Driver Assortment you can get on Amazon.

I found a few different versions but they were too big and bulky or didn't look like they would hold the drivers straight. I wanted something pretty solid that could sit on a desk, in a toolbox or hang on a wall.

Holders are tapered for a snug fit so you can use this on a desk or mounted to a wall. The 3 smaller sizes fit from the top-down or clip-in.

The slots are a friction fit so these are held very well.

There are two versions. One with a back-plate and one just the holder that you'll need to drill holes-in to mount.

Back is a little thicker than required but I like the weight of it.

Can be printed flat as the overhang is not that bad on the cones.

Print Settings

Printer:

FLSUN i3 2017 Version

Rafts:

No

Supports:

No

Resolution:

.3

Infill:

25%

Filament: Amazon Basics PLA Orange

Notes:

Can be printed at .2 or .3 and any infil as it's not supporting a lot of weight.

I thought about engraving the size but the drivers have the size on the handle and the bit - so I opted not-to.

Category: Tool Holders & Boxes

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License