Better Seams: An Orca Slicer Guide to Using Scarf Seams
Voron 2.4 CoreXY
1
March 3, 2024 at 11:46 PM
Original model
Comments
@SBui_270637 Yes, this is definitely possible, particularly when using slower speeds along with extrusion smoothing and other tweaks. Generally inner/outer/inner works slightly better, but obviously for overhang cases the advantage of wall order can outweigh the slight quality increase. (edited)
Great improvement on seams (Voron 2.4 R2 revC)
I managed to get very decent results even keeping the "Inner/Outer" wall print order (best for overhangs)