Pimoroni Display Pack Case - With cutouts for PICO(W)-H

No special print settings, I have printed approximately 40 of these for School… case works well with multiple students working on them.

Updates:

Completely recreated the case in onshape.  I wanted a case that was not simply held together by friction, as some prints were becoming loose.  In my classroom environment, this setup gets used a alot, and sometimes keeping them protected is difficult.  So far over a two year period I have lost 2 due to failures. 

I modified the case to have a built in latch to keep the case from coming apart, as well as modifying the fit a little.

There are two variants of the new case top available:

1. A case top that has no access to the internal clips, so once put together, its not coming apart, unless the case is broken.
2. A case top that allows access to the internal clips. so the case can be disassembled.

Note:

While I made the new models, they are derived from the remix, so I'm leaving this marked as a remix.

Note:

This case is for a PICO with a Display Pack (1.3") NOT the Display Pack 2.  For a case that is designed for the Display Pack 2, see:

https://www.printables.com/model/920520-pimoroni-display-pack-2-case