Strain Relief Voron V0.2 Umbilical Dragon Burner w/Orbiter

I made this small bracket to provide some strain relief for the umbilical on my Voron V0.2.

It fits the Dragon Burner toolhead by chirpy2605 with an LDO Orbiter extruder.

I think I was lazy when routing my V0's cabling - I didn't really follow the guide. I ended up routing my cables near the cabling of the Orbiter extruder's motor. These cables probably need some strain relief so this simple bracket attempts to do that.

• Use 2x M3x8 bolts to attach to the toolhead board mounts (I'm not using one). 
  • Check that the bolt heads clear the A/B motor drive units when at Y0. You might need bolts with small heads (mine just miss the motor drives!).
• Loop a small cable tie through the hole to secure your cabling.