I wanted to create something new to challenge myself. And this is what i came up with. I took me a lot of time but i am happy with the results. Tell me what you think!
Print instructions
Info
You can print with any Settings you want. This is only my recommendation.
Assembly
In case of any problem you can try this
Depends on your printer calibration
If the Ratchet can turn without „clicking“ then you need to increase the scale.
If the Ratchet can not turn you. Try to beak it. Then try with a Spring(6) scaled down.
Print settings
A | B | C |
0.2 mm layer heigth | 0.2 mm layer height | 0.2 mm layer height |
Print outer layer first | Print outer layer first | Print outer layer first |
20 % infill | 25 % infill | 100 % infill |
4 perimeters |
The author marked this model as their own original creation.