Who doesn't know the typical wooden louvre doors, usually on landlord cupboards or the typical ones you get in DIY stores, where a louvre is approx. 33x6mm in size.
I was now faced with the problem of hanging something up there. It had to be stable and shouldn't fall down when the door is opened.
Drilling would have been perfect, but you don't do that - so I designed a holder that I screwed to the object to be attached and then clicked the object into the slat. Removal is similar, simply push the slats apart a little and pull the object off again. You can attach something to louvre doors without causing any damage. Printing time approx. 15 minutes in PETG. Here is the blender file for people who want to customise it.
✄ - - - - - - - - - - - - - - - - ✄
Wer kennt nicht die typischen Holz Lamellen Türen, meist bei Vermieter Schränken oder die typischen die man so im Baumarkt bekommt, wo eine Lamelle ca 33x6mm groß ist.
Ich stand jetzt vor dem Problem das ich dort was aufhängen sollte. Es sollte stabil dort halten und nicht beim öffnen der Tür runter fallen.
Anbohren wäre perfekt gewesen, aber das macht man nicht - also kurz einen Halter entworfen den man an dem zu befestigenden Gegenstand anschraubt und dann den Gegenstand in der Lamelle fest klickt. Entfernen geht so ähnlich, einfach die Lamellen etwas Auseinanderrücken und den Gegenstand wieder abziehen. Ohne schaden zu hinterlassen kann man so etwas an Lamellen Türen befestigen. Druckzeit ca 15 Minuten in PETG. Anbei die Blender Datei für Leute die es anpassen wollen.
The author marked this model as their own original creation.