Raspberry Pi 5 Case (with 30mm Fan mount)

A 2-part case with multiple variations for the Raspberry Pi 5. Compatible with official RPi5 active cooler.
8
119
0
1117
updated November 17, 2023

Description

PDF

Hi,

These designs were made to be compatible with the Official Raspberry Pi 5 Active Cooler, although it is not required...

I also included designs for the bottom halves that removes access to the SD Card, should you run your OS off an external SSD.

All designs have access to the Power Button.

There are multiple variations of the two halves that can be combined however you desire.

 

The fan mount variation was made for a 30mm Fan.

 

***The Case Stand is slightly undersized because it was designed to be printed with TPU!!  It probably wont fit around the full case if you print in a rigid material (PLA,PETG,etc.)***


For Assembly:

Hardware Required:

4 x M3 x 16mm Hex Socket Cap Screws (or Eq.)

4 x M2.5 x 6mm Flat Head Phillips Screws (or Eq.)

 

For 30mm Fan Mount (Optional):

4 x M2.5 x 12mm Hex Socket Cap Screws (or Eq.) with Washers

(This is just my set up for my specific Fan I used... You may need to use an 8mm or 10mm Length)

Don't over tighten the screws. May need to run a small drill through the Top Half M3 holes to slightly open it up.
 

 

My Print Settings:

No rafts or supports required.

.3 layer height with a .6mm Nozzle

Filament: PLA, PETG, TPU

Infill 15-20%

 

 

Tags



Model origin

The author marked this model as their own original creation.

License