Just a simple organic tea light.
Printing :
0.2mm layer height works well.
Layers and Perimeters:
Under Advanced set the Seam Position to Rear
Enable organic supports.
Please see screenshots below for the organic support settings that I used.
CAUTION:
Please be careful that you don’t break off the first layer expansion of the support when you remove the lamp form the bed. DO NOT PULL AT THE BRANCHES! A sharp spatula generally works well to remove the first layer filament but be carful not to scratch your print sheet.
I hope you will enjoy this lamp and may it bring a sense of zen into your home.
If you like this lamp, please check out my other creation: https://www.printables.com/model/626698-the-tree-of-light
The author marked this model as their own original creation.