This vinyl record wall-mounted display bracket was designed specifically for use with these screw hooks, but it will likely work with other similarly sized “bear claw” style screw hooks. You will need two of them for this display bracket.
Print the bracket and template in the orientation shown below.
Installation:
Decide where you want your display bracket to go and then use a bubble level to level the template.
Mark the holes for the screws using the two holes in the leveled template.
Screw the screw hooks into the wall at the marked locations.
Slide the display bracket down over the screws (you may have to make slight adjustments to how tight the screw is to the wall to get the bracket to fit over the screws nicely).