Slim front side AMS (and Hydra) narrow side corners silica dryer pod/drybox with snap fit lids for Bambu Lab AMS

UPDATE 1.02.2024: 

Lids with Bambu-Logo handle for small and big AMS dryer pods The perfect-fit funnels for big and small silica buckets

 I think the silica boxes in AMS are simply brilliant, so the filaments can stay in AMS for a long time and be kept dry for a very long time! The silica gel can simply be dried in oven or microwave and used again - top!

When changing silica, I wondered whether boxes should also exist for the narrow sides/corner niches on the far left and far right in AMS? I discovered a few models at printables, but they did not fit the design of my existing ones, did not have a "snap fit" lid, or grid was so oriented that they could not be printed cleanly. So, I allowed myself to remix two models - that's what it's all about!

These side boxes are fully compatible with the Hydra AMS! (proved by Hydra Users)

Print Instructions: (important changes for this filigrane model)

Quality:

• layer height: 0.15mm

Strength:

• wall loops: 2
• top shell layers: 5
• bottom shell layers: 3
• sparce infill density: 20%

Speed:

• first layer: 20 mm/s
• first layer infill: 20mm/s
• outer wall: 50 mm/s
• inner wall: 50 mm/s
• small perimeters: 50%

Others:

• Brimtype: outher brim only
• Brim width: min 5 mm

This model should be printed slowly and needs maximal cooling for nice finish of grid - better place them close to AUX Fan and set this (after first 1-4 layers) to 70%.

It is helpful to swith your Bambulab Printer from “Standard” Speed to “Quiet”!

Filament: PLA is good enough!

— ! — 

Thanks in advance for downloading and please don't forget to like this model!

Take a look at my other very helpful models for X1/P1P/P1S:

 - Powerful magnetic Bambu Lab/Bambulab X1/P1S/P1P (AMS Hub compatble!) Exhaust Fan Muffler / Fan Silencer without Supports/Bridges!

- Your BambuLab X1 /P1P/P1S doesn't have enough space in the back for poop collection? Print this slide for side collection!

- BambuLab AMS Feeder Button Cover

- Do you start to smell melted plastic when printing? Time to replace filter! Or print this one and fill it with carbon!

If you like my work and want to support me - please follow me and if you want -  you can buy me a coffee! https://linktr.ee/eds_3d_shop

Thank you for your support and.. happy printing!

Ed ;-)

I remixed the slim box to have a snap-fit lid and vertical holes for less bridging, like in the bigger box.