This is an adapter that converts a DELL monitor stand into a VESA stand.
Compatible with stands labeled “FFT-ZS”.
Please let me know if you can use this model other than those listed below.
Layer Height: 0.2mm
Around the fixing hole: 100%infill
Other: High infill rate
no support
I printed with ABS-CF 0.6 nozzle 50~100%infill.
Remove the bridge from the three central holes after printing.
M4L8 screw ×3
M4 washer(4-10-0.8) ×3
M5 washer(5-12-0.8) ×4
The author marked this model as their own original creation.