Panther

Panter Logo using hueforge and filament painting.

This model is quite thick (7mm) and mostly wanted to test how carving a thicker model will look like. It will take time to print and expect some stringing.

Recommend to use tight brim to keep the model on the table

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA Overture Black
• PLA PolyTerra Charcoal Black
• PLA Overture Cement Gray
• PLA+ Sunlu Gray
• PLA Overture Light Gray
• PLA+ Esun Bone White
• PLA+ Sunlu White

Swap Instructions:

• Start with Black
• At layer #12 (1.04mm) swap to Charcoal Black
• At layer #15 (1.28mm) swap to Cement Gray
• At layer #20 (1.68mm) swap to Gray
• At layer #26 (2.16mm) swap to Light Gray
• At layer #40 (3.28mm) swap to Bone White
• At layer #47 (3.84mm) swap to White for the rest.

Enjoy my work? Support me by joining my club. Tier 1 offers exclusive models, while Tier 2 allows you to sell my 3D printed artwork.