BTT Manta M8P - Cooling Shrouds, DIN Clips, and Board Mounts

2 different cooling shrouds for the BTT Manta M8P.

1.  using the CB1 w/heatsink (leg lengths match the heatsink, use 10mm and 12mm M2 screws, longer ones toward the edge of the board), it uses 4x 4010 fans, 3 on the drivers, 1 on the CB1 w/heatsink
2.  using 3x 4010 fans on the drivers.  Any combination of CM4/CB1, with or without independent heatsink/fan. No cooling on this shroud for CM4/CB1 module.  Theres enough clearance for any CM4 heatsink/fan combo, that ive seen commercially available, to be used on the module.

The screws pass from the back of the board, to the front, so if your using DIN clips and board mounts (in the files) you open up the screw holes of the clips and mounts with a 3mm or 3.2mm drill bit, so the screw will pass through without grabbing, and youll be able to feel when the screw grabs the threaded insert of the shroud feet and snugs up.

The threaded insert holes are 4.2mm, so all M3 variants should fit.. 

20x M3 Inserts for the CB1/Driver cooling combo shroud: 4x legs, 12x driver fans, 4x CB1 fan.

16x M3 Inserts for the driver cooling shroud: 4x legs, 12x driver fans.