When I started my remote work job they sent me 3 monitors with no way to elevate them and I spent a whole year killing my neck and back with them being way too low. Every time I got the desire to remedy the situation I was dissuaded by being cheap and not wanting to spend $100+ on monitor stands. Instead I did the next rational thing, I built a big Voron and designed this, which almost uses a whole roll of filament. Worth it.
Print Settings
Material: Most things should work
Walls: 5+
Infill: 50
Orientation: On the back (refer to image)
I printed mine in both PETG and PLA and both are good enough. Definitely give it like 6 walls and a good amount of infill. To eliminate the need for supports I printed mine “on it's back”. As long as you have good layer adhesion it should work.
Materials
6x 10mm rubber feet (optional)
I designed in provisions for 6 10mm rubber feet to make sure they don't slide around, but with enough weight and desk pad mine have been sitting still.
The author marked this model as their own original creation.