Container for small SMD Components

A small containers of approximately 1 cubic inch, for small SMD components which can be easily endlessly connected to each other in both directions, to form array of small boxes for electronics component storage. 3D print as much as you need, connect it together for easy component storage. Of course these containers can be used for all small stuff you need to keep organised, like: screws, washers and nuts…

Important: this is not ESD approved, so avoid to store MOS semiconducters. It is safe for all passive components as well as non MOS semiconductors. 

You can print your own labels to place on the container's lid, where you can find guidelines. There is a Label Frame, if you wish. This Label Frame is suitable for papper lablels (12x19 mm), which can be placed under this frame. The frames don't need to be glued: just press them in two holes in the lid. The lid's holes may be needed to clean up after print. 

No print support is needed.