This fender/mudguard kit is designed so that the mount plate and fender block as much area between the battery packs to keep your shock clean and dry. It's also designed so that you never have to use the garbage stock mudguard ever again.
I wanted something sort of classic looking, but still blocky and bold to match the T4 and Master design.
The mount plates are nice and strong and the fender can be attached using the original mudguard 4mm screws. If I get enough requests, I'll load a version that can mount with zip ties for even easier installation/replacement.
The fenders are printed 1.5mm thick for weight savings, so they're not incredibly strong, but they're easily reprinted/replaced. So far so good with every day riding. If they start to break too frequently, I may load a 2mm thick fender.
NOTE: You may want to print the rear fender in TPU. PLA fenders will break after enough riding.
Printing:
Refer to the images for suggested printing orientation and supports.
You'll need supports on the fender and use a brim for bed adhesion. Mount plates don't need support, but 20-30% infill is suggested for strength.
Installation:
Refer to the images. Mount the plates on the stock metal flaps between the battery packs with some strong Velcro, and use the original M412 screws that mount the original mudguard.
Changelog:
2023-05-21:
Changelog:
2023-05-30:
Changelog:
2023-06-15:
The author marked this model as their own original creation.