Bambu Lab Filament Spool Winder - Filament Guide, Filament Guide Sled, Filament Guide Carriage and Knob M3 Heat Threaded Insert

Nice.

Did you think about a little chamfer at the bottom of the ptfe tube holder?

Prusa MK4
December 20, 2023 at 1:33 PM

Comments

Ctrl + Enter to send Enter to add a new line

@Damian27 The holder for the PTFE hose runs back and forth over the half gearwheel :) At the moment, this bracket ends with a sharp edge, which can lead to a blockage if the gear is not perfectly seated. If a small chamfer (1-2 mm) were added, the risk of this happening would definitely be minimized.
But maybe that just doesn't happen. I haven't tested the part properly yet. Best regards!

@MeisterEdel Hi. I don't quite understand what you mean? Thanks for Printing