Adjustable Phone Stand V3

If you have any tips or advice about how i could make this better, please feel free to let me know, im open to all advice and help
You Might need to sand some parts to fix some tolerances, those parts being the pins, and the connectors for the Support and Base Bottom parts

Print Settings

• Frame Parts
  • Base Sides (Print both Left and Right at same time)
    • Lay on side with the indent facing up
    • 25% Infill
    • 0.2 mm Layer Height
    • 4 Walls
    • 5 Top/Bottom Layers
    • No Supports
  • Hooks (Print both Left and Right at the same time)
    • 25% Infill
    • 0.2 mm Layer Height
    • 4 Walls
    • 5 Top/Bottom Layers
    • No Supports
  • Support Bar x2 (Print 2)
    • Lay on side with the indent facing up
    • 25% Infill
    • 0.2 mm Layer Height
    • 4 Wall
    • 5 Top/Bottom Layers
    • No Supports
• Supports
  • Base Bottoms (Print both Front and Back at the same time)
    • 25% Infill
    • 0.2 mm Layer Height
    • 4 Walls
    • 5 Top/Bottom Layers
    • No Supports
  • Support
    • 25% Infill
    • 0.2 mm Layer Height
    • 4 Walls
    • 5 Top/Bottom Layers
    • Use Supports
• Pins
  • Print All 3 Pins At Once
    • Do Not Rotate them Keep them on their sides for best strength 
    • 45% Infill
    • 0.2 mm Layer Height
    • 4 Walls
    • 5 Top/Bottom Layers
    • Supports

How to Put it together
Step 1: Print all the parts

Step 2: Take the Left Hook and the Top and Bottom Pins, and put the top pin all the way through the hole at the top of the hook, and put the bottom pin through the hole at the bottom of the hook 

Step 3:  take the Right hook and put it on the other side of the pins

Step 4: take the support bar, support, and support pin and assemble them like it is in the image

Step 5: take the second support bar and put it on the other side of hooks

Step 6: Take the Base Sides and put them on the bottom pin like so

Step 7: Take the Base Bottoms and attach them to the base sides, once you do that the phone stand should be done