SV06 Bed Leveling Test

A quick test for adjusting your Z-Probe Offset while printing with the SV06, it draws the skirt right next to the purge line, check this in your .gcode file with your slicer beforehand. You can adjust your Z-Probe Offset while printing until you get the desired results. Make sure to Autolevel your bed before doing a Bed Level Test.

Layer Height:

0.2mm

Printing Speed:

45mm/s

Perimeters/ Wall Line Count:

3

Print Temp:

215°C (for PLA)

Bed Temp:

60°C (for PLA)