This fan shroud is optimised for use on the Prinrbot Simple 1405 with an E3D v6 Hotend. In theory it also works with the Ubis, however I can not guarantee, that it lines up correctly.
There is a normal version (redone) available that works on the same principle as the original printrbot-shroud.
The other version (redone deflector) has a ring of material that goes all the way around the hotend. It doesn't look like much, but I have found that this makes quite a dramatic difference in airflow direction. It even prints without supports; thats tested with the cheapest PLA that was available.
Just watch out, when heating your bed above ~60°C with the hotend close to it and the cooling fan not running, the deflector might sag down onto the bed.
For a more advanced, omnidirectional version, check out this thing: http://www.thingiverse.com/thing:655807
Category: 3D Printer AccessoriesThe author marked this model as their own original creation. Imported from Thingiverse.