iPhone MagSafe Charger Wall Mount

Post a make if you print! I would love to see it.

Mount this design to the side of your bedside table or desk with double sided tape (I strongly recommend thick tape, I used “Scotch-Mount Extreme Double-Sided Mounting Tape 2.5cm”), then insert your MagSafe puck for easy wireless charging. 

Apple's MagSafe is great but I find it annoying to get the puck off of the back of my phone. Rather than simply picking my phone up when it's done charging, I have to pick it up, pry the puck off the back of my phone, and then place the puck back down on my desk (first world problem I know). 

This design solves this issue, by turning your MagSafe puck into a vertical-mounted phone stand that your phone snaps to. It also has the added feature of the MagSafe puck being easily removable from the stand, in case you need to use your phone while it is charging, or to charge other devices such as Airpods.

Phone Compatibility and printing

Files have been added for every iPhone that supports MagSafe, as well as variants for said phones with cases. If you have a case it must be MagSafe compatible to work. Dimensions in the file names refer to the dimensions of the phone (including the case for the case variants) that said file is designed for.

The case variants are based on a Mous case which adds 5mm total height to the phone. These different heights are needed for the base stand's position as the Magnets are not strong enough to hold the phone in place through the print.

Print with an outer brim if having adhesion issues.

Changelog:

Feb 2nd 2023: Added small protrusions at the base to secure the bottom of the phone as I found that if the top of the phone was knocked back slightly while trying to take it off the charger, the bottom would come forward and the phone would fall off the mount before you can grab it properly.

Aug 5th 2023: Changed width's to match phone sizes instead of all models having the width of the largest phone. Makes it easier to grab smaller phones by their sides.