Pot With Lid | Minimalist Jar With Lid

Three minimalistic pots with lids in three different sizes!
The pots can of course also be used without the lids, I have kept the edges of the pots clean for this purpose.

The model has no critical overhangs, so everyone should get a wonderful print result. 
By the way, this model can also be scaled very well. If you are unsure whether the lid will still fit into the pot if the size changes significantly, you can cut off the pot and print only the upper edge for testing.
Please follow the print instructions below to get the best result!

Print instruction:
I recommend printing the lids with a layer height of 0.2mm. 
3 perimeters and 10% infill are sufficient. The slightly angled top of the lid can be printed with a layer height of 0.1 to 0.12mm for a nicer result. This can be set in the Prusaslicer via "Variable layer height" as shown in the picture. The color change is best set to the height where the diameter of the sphere is somewhat equal. But of course this is up to you.

I recommend printing the pots with a layer height of 0.2 to 0.25mm. 3 perimeters and 10% infill are sufficient. From a height of 20mm, the infill can be set to 0%, the pot is still sturdy.

If you like this project, check out my other designs too!