The original caused me several problesms: 1) It was massive, and would not fit on evern the MK3S+ Bed. 2) Everytime I printed it (after resizing to max height 200mm), the hip would disconnect from rump 3) I wanted a hook to connect the deer to each other and the sleigh 4) excessive stringing of the antlers.
I tried large brims, still no luck, so added a large oval (1mm height) to secure all four (4) legs to one platform. Used draft shield up to 400 lyaers (stopped before got to antler height.)
Still needed support for the back most leg. The support was painted on, and easily came off with just thumb pressure around the base.
I watched MakerMuze video on stringing, which helped me quite a bit. Discovered (accidently) that printing at 130% speed worked better than slower (say 80%). Stringing still not ideal, but much better. If you have better results, let me know. Used the height range modified to change .20 layer height to 0.10 at 133mm.
Recommend trying the gcode first.
The author remixed this model.