This remix is for a direct drive Ender 3 (Pro/V2) to use the system as reverse bowden setup with the aperture science logo. you will need a standard 4mm outerdiameter bowden tube, that feeds into the inlet of your extruder. you also need a new filament spool holder, that sits on the left side of your printer. this way, you can print easier out of filament dry boxes or just get rid of the top mounted spool holder
i cleaned out the hole with a 4mm drill bit and then pressed the bowden inside te hole until it was flush with the camfer, then you can cut the bowden to fit the 45 degree angel or just leave it.
Category: 3D Printer Parts
The author marked this model as their own original creation. Imported from Thingiverse.