Pegboard (Metric) - Nut Driver Holders

NOTE : These pegboard organizers are for Metric type pegboard: 22mm spacing between holes 6mm holes thickness approx.
7h 14m
4× print file
0.20 mm
0.40 mm
85.00 g
11
77
1
741
updated February 28, 2020

Description

PDF

NOTE : These pegboard organizers are for Metric type pegboard:

22mm spacing between holes
6mm holes
thickness approx. 4mm

(A separate US pegboard version is also available.)

NOTE 2 : Warning - untested! These files are a variation of the US pegboard version I made for myself. I don't have any Metric pegboard to check these on, but it was a simple modification to make so I thought it might be useful to some people.

These are for 7-piece sets of nut drive holders. "Nut drive holder1" was made for metric nut drivers from Harbor Freight; "Nut driver holder2" is for 3/16" to 1/2" nut drivers from Craftsman.

Not all nut driver sets have identical shaft sizes, so check yours before using these prints. My nut driver sets have the following shaft sizes:

Metric : 10mm, 7.7mm, 7mm, 7mm, 7mm, 5.85mm, 5.85mm
Craftsman : 0.435", 0.435", 0.313", 0.313", 0.313", 0.246", 0.246"

Each holder consists of a main section with insertable pegboard hangers. Each holder can take up to four insertable hangers, but I found that two hangers are sufficient.

The OnShape 3D CAD files for these prints are available here:

https://cad.onshape.com/documents/6550d6e4599c45d41be3b284/w/d7a9e0740023cdefc108ddfc/e/97ebca743bdb100d246f3999

Print instructions

For the holder section:

Rotate piece Z by 40 degrees to fit on bed.

Infill: Fill density = 10%
Fill pattern = rectilinear
Top fill pattern = concentric
Bottom fill pattern = concentric
Fill angle = 95 degrees

Perimeters = 3 minimum
For the hanger pieces:

Print on side with a brim. If you use the provided .3mf file it will print both pieces one at a time.

Tags



Model origin

The author remixed this model.

License