Anker 341 (A8346) Steam Deck Dock Enclosure (Updated v2 Design)

V2 DESIGN DOES NOT SUPPORT KILLSWITCH YET (will come in V3 Design)

Converts the  Anker 341 (A8346) USB-C Hub into a fully enclosed Steam Deck Dock. V2 Design means new snap design and no more screws needed.

Tolerances were made for printing at 0.3mm layer height.

IMPORTANT! Print the top piece as mesh, if the hubs are fully enclosed they will 100% overheat! (top layers: 0, bottom layers: 0, wall line count: 8, infill pattern: lines, infill density: 22% or less) 

Bottom Piece can be printed similarly, your choice. (my bottom is mesh)

Optional Parts

USB-C 3.1 Right Angle Adapter/Extender https://www.amazon.com/dp/B08CDGHQWF

Make sure to have supports enable if your bridge settings are not good!

To Purchase One

Head over here, mogindustries.com or here https://www.etsy.com/shop/MOGindustries