This is a dropper bottle holder for miniature acrylic paints. I made it specifically to fit in an ArtBin and accept Army Painter bottles. They are 24mm in diameter which should also accept Vallejo and other 18ml paint bottles.
It is broken into 2 bottom plates and 3 upper plates to fit on smaller print beds. The top and bottom should snal together but might require a little sanding depending on your printer tolerances. Gluing is optional but I would recommend it to make it stronger.
There are three small protrusions designed into each to hole providing just enough resistance to hold the bottles in even if held upside-down.
It is sized to fit in a 12" Art Bin Quick View carrying case. There is a little room leftover for a couple miniature stands and a few brushes. https://www.amazon.com/ArtBin-12-Inch-Carrying-Container-6977AB/dp/B001ELDERU/
Printer Brand:
FlashForge
Printer:
FlashForge Creator Pro
Rafts:
No
Supports:
No
Resolution:
.2mm
Infill:
20%
Notes:
No supports are needed and it should be printed on the large flat side on the bed with pillars building up from the build plate. This probably requires a 90 degree rotation in your slicer.
Category: Art ToolsThe author marked this model as their own original creation. Imported from Thingiverse.