This is my very first model trying to create something useful. It is a toothbrush stand for a Silk'n Toothwave electric toothbrush.
I was actually looking for a way to place my toothbrush without having to glue or screw anything to the wall so I decided to create a clip-on stand which is fitting my glass holder. This way also the satand does not touch the ground anywhere and does not impact any cleaning. Speaking of cleaning I did on purpose not include any bowl at the bottom where water can be collected but instead went for a central stand inspired by the wireless charging station.
Sure it might not fit your cup holder but you might remix the file if you want to re-use the base stand design or similar. Have fun.
Printed on Anycubic Vyper (can't select this model here).
Printed upright. Supports only needed for the side-platform rail-guards. Used Cura slicer and set support blockers everywhere except the down facing platform ovals on the outside with an overhang angle of 85°. Included a gcode file which worked for my Vyper.
I used only 10% Gyroid infill and it's sufficiently stable using PLA filament.
Printer Brand:
Anycubic
Printer:
Photon
Rafts:
Yes
Supports:
Yes
Resolution:
0.2
Infill:
10% Gyroid
Filament: Purefil PLA black
Notes:
10% Gyroid infill.
Supports only on the downfacing oval platforms on the outer sides.
Printed upright.
Category: BathroomThe author marked this model as their own original creation. Imported from Thingiverse.