Everyday Individual Screwdriver Holders

Various Individual Screwdriver Holders
1h 33m
1× print file
0.20 mm
0.40 mm
17.00 g
5
22
1
286
updated February 19, 2022

Description

PDF

Although I have since found similar on prusaprints my remix came from https://www.thingiverse.com/thing:2918462/files.

Again looking for individual holders for my various and individually purchased screwdrivers to mount in a small area. The ones I fell upon were for a set or sets of Wera screwdrivers, BUT hole sizing a little small for my day to day screwdrivers.

I have initially made some blanks for anyone to do there own thing using a small shaft hole so that you can easily increase as needed.

The originals appeared to be mounted on a piece of ply away from the wall making it easier to remove said screwdriver. As this was not going to be available to me I made the bases 4mm thicker and reduced the original angle from what appears to be 10º to 7.5º, so as to accommodate slightly longer screwdrivers.  I also have increased the mounting screw holes to 4mm.  I have included where possible my fusion 360 file also.

I had no need for the numbering system and just went for S,M,L A multi colour filament printer would have been better than my maker pens.

Remember to set the base flat to print plate before gcoding.

Pozi Drive

  • S  = 4.5mm Diameter 
  • M = 6.5mm Diameter 
  • L  = 8.5mm Diameter 

Slotted

  • S  = 5.5mm Diameter
  • M = 9.5mm Diameter
  • L  = 13mm Diameter

Electrical

  • 7.5mm Diameter

 

Tags



Model origin

The author marked this model as their own original creation.

License