Christmas Ball

Worked great on my old MK2!

December 8, 2021 at 10:25 PM

Comments

Ctrl + Enter to send Enter to add a new line

Thanks! It is printed in vase mode, which is why the very thin top (at 0.15) couldn't handle the glued on hanger.

mrquackers That looks nice! :)
I suggest to print in vase mode (or Spiralize) to have the best exterior finishing and to keep it as lightweight as possible.

Printed in Geektech Silk Silver, on a Prusa Mini it looks best in 0.15 layer height through the middle and 0.25 height on top and bottom 5% or so for strength. I made a quick superglue-in fitting for the top hole that takes a piece of ribbon. Also printed in no-name silk gold at 0.15 throughout, but the hanger broke off from the top layers being too thin. Thanks for the model! (edited)