Printed the 300 mm versions in ASA for my enclosed RatRig 400mm. Aside from my own issues with ASA, these printed pretty well. I do have a couple of complaints: the angle for the lights is not optimal for the 400mm and I wish there was a version for it; the slot for the LED's is tight and you'll have to solder your wires on after its in the mount and it's a tight fit (I had a hard time getting heat shrink shoved in on one side to get the other side out far enough to solder). Overall, I like the design and think they look great in the unit. Just could use a few tweaks imo.
Printed the 300 mm versions in ASA for my enclosed RatRig 400mm. Aside from my own issues with ASA, these printed pretty well. I do have a couple of complaints: the angle for the lights is not optimal for the 400mm and I wish there was a version for it; the slot for the LED's is tight and you'll have to solder your wires on after its in the mount and it's a tight fit (I had a hard time getting heat shrink shoved in on one side to get the other side out far enough to solder). Overall, I like the design and think they look great in the unit. Just could use a few tweaks imo.