Because there was no stl available, I couldn't slise the file on MK4, so it printed very long and in lower quality. Then I found out that it was too big for my fingers, but I couldn't make the model smaller. I would need stl. In the end, I at least heated the print and slightly deformed it so that it would fit at least on my thumb. I believe that when the table becomes available, all these ailments will disappear.
Because there was no stl available, I couldn't slise the file on MK4, so it printed very long and in lower quality. Then I found out that it was too big for my fingers, but I couldn't make the model smaller. I would need stl. In the end, I at least heated the print and slightly deformed it so that it would fit at least on my thumb. I believe that when the table becomes available, all these ailments will disappear.