Very, very nice model! I enjoyed slicing and printing it very much!
I used 0.2 mm layer height with selective adaptative layer height down to 0.08 mm on the hood (bonnet) and the top. I used ironing on all top layers also.
I didn't do anything special for the interior.
I opted for a 15 degree threshold angle in the supports to avoid having support around the seat for the interior.
The thing was full of support, but they were very easy to remove since my filament is very well tuned.
Very, very nice model! I enjoyed slicing and printing it very much!
I used 0.2 mm layer height with selective adaptative layer height down to 0.08 mm on the hood (bonnet) and the top. I used ironing on all top layers also.
I didn't do anything special for the interior.
I opted for a 15 degree threshold angle in the supports to avoid having support around the seat for the interior.
The thing was full of support, but they were very easy to remove since my filament is very well tuned.
Took 3h to print on my Bambu Lab P1S