Awesome design. I think it looks great. Even before I installed the LEDs I could see into the printer significantly clearer. The small lower rails were very challenging to remove the support from without breaking them. I tried to use PLA for the support interface, but the petg would not stick to it long enough to finish printing. So I increase the thickness of the rails and its support posts, which worked great. I had some printing blemishes after the tops of the holes, tried 2 petg materials and had the same blemishes. I will modify this more before printing again. I would like to be able to push the glass cover further back. I printed this on a P1S with bambu petg. .2mm layer height default standard setting with tree supports modified to be closer together.
Awesome design. I think it looks great. Even before I installed the LEDs I could see into the printer significantly clearer. The small lower rails were very challenging to remove the support from without breaking them. I tried to use PLA for the support interface, but the petg would not stick to it long enough to finish printing. So I increase the thickness of the rails and its support posts, which worked great. I had some printing blemishes after the tops of the holes, tried 2 petg materials and had the same blemishes. I will modify this more before printing again. I would like to be able to push the glass cover further back. I printed this on a P1S with bambu petg. .2mm layer height default standard setting with tree supports modified to be closer together.