XYZ Davinci Pro 1.0 part cooler fan mount

I have converted my XYZ Davinchi Pro 1 from bowden to a direct drive using the original carriage, but new controller…
1
7
0
91
aggiornato 5 maggio 2023

Descrizione

PDF

I have converted my XYZ Davinchi Pro 1 from bowden to a direct drive using the original carriage, but new controller board. I'm using a BMG extruder with e3dv6 hotend.

As I was unable to find any part cooler fan-mount I have designed my own – no modifications, drilling etc is necessary, but it can be difficult to assemble. So be warned. To maker it easier you can drill the hole on cariage a bit larger and on the Titan extruder to allow room the bolt.

2020-04-13:

Part-cooler changed so it can be fastened with two screws for improved stability.

2020-04-09:

I have now changed to a BMG extruder - this makes it easier to fit the part-cooler. Still no need to drill any holes.

Added pictures of the configuration.

2019-07-08:

Updated the fan-duct design again.

2019-05-14:

Added a new improved fan-duct-2.stl. It is a bit smaller to make a more tighter fit and some round corners for improved printing.

Note:

The back.stl is bolted to the titan extruder, which is the reason for a very long screw.

BOM:

A fan 50mm

3x4mm screw and bolt

2 3x3mm screws and bolt for the fan

Fusion360 link - fan mount: https://a360.co/2Hbou4O

Fusion 360 - Fan duct: https://a360.co/2S1LRmM

Print Settings

Supports:

Yes

Resolution:

0.2mm

Infill:

15%

Filament:

Filament PM PLA and ABS


Notes:

Fan mount is printed in PLA
Fan duct in ABS - print with support

Category: 3D Printers

Tags



Origine modello

L'autore ha contrassegnato questo modello come una sua creazione originale. Importato da Thingiverse.

Licenza


Modelli in evidenza dal creator

Vedi altro