CREALITY K1+K1C LID RISER V1

*If you have any issues with printing or assembly, feel free to message me, and I'll do my best to assist you 😉.

NEW VERSION: 

https://www.printables.com/model/890518-creality-k1k1c-lid-riser-v2-50mm-height

/////ATTENTION

Make sure the bolts (bolt version) aren't too long. They shouldn't go past the frame's thickness to avoid damaging any internal components.

*The PLA version has some tolerances that are too tight. Everything works, but not like with ABS. The final version was adjusted for ABS. I'll revisit the PLA version and update the project.

Depending on whether you're printing in PLA or ABS, use the STL files for the corners labeled PLA or ABS. All the parts are the same except for the corners. In the ABS version, the walls are 0.75mm wider due to material shrinkage when cooling. This difference ensures there are no gaps between the pieces. However, if you encounter any fit issues, I've included STEP files so you can adjust the corners to better suit your printer.

*Approximately 235g of filament

/////BOM to print (alll versions - ABS or PLA):

• 1 x LID_RISER_K1C_BACK_VENT
• 1 x LID_RISER_K1C_BACK_WALL
• 1 x LID_RISER_K1C_BUMP_VENT
• 1 x LID_RISER_K1C_BUMP_WALL
• 4 x LID_RISER_K1C_HANDLE
• 2 x LID_RISER_K1C_NORMAL_VENT
• 2 x LID_RISER_K1C_NORMAL_WALL

/////CORNERS for ABS version

(without bolts)

• 1 x LID_RISER_K1C_BUMP_CORNER_ABS (without bolts)
• 3 x LID_RISER_K1C_CORNER_ABS

(with M3x55mm bolts)

• LID_RISER_K1C_BUMP_CORNER_ABS_BOLT
• LID_RISER_K1C_CORNER_ABS_BOLT

/////CORNERS for PLA version

(without bolts)

• 1 x LID_RISER_K1C_BUMP_CORNER_PLA
• 3 x LID_RISER_K1C_CORNER_PLA

(with M3x55mm bolts)

• LID_RISER_K1C_BUMP_CORNER_PLA_BOLT
• LID_RISER_K1C_CORNER_PLA_BOLT

/////ABS OPTION

I used the preset settings for ABS in OrcaSlicer to print.

The extruder and bed temperatures depend on the type of filament being used.

*I'd recommend preheating the chamber to at least 40ºC before starting the print. Only activate the chamber fan after it reaches 50ºC.

/////EXTERNAL WALLS

Outer brim only:

Brim width: 5 mm

Brim-object gap: 0 mm

Supports: only on the Back Wall, at the tube entrance

Seam position: Back

/////VENTS and HANDLES

Outer brim only:

Brim width: 1 mm

Brim-object gap: 1 mm

Supports: N.A.

Seam position: Back

/////CORNERS

Outer brim only:

Brim width: 5 mm

Brim-object gap: 0 mm

Supports: N.A.

Seam position: Back

/////BUMP WALL

Outer brim only:

Brim width: 5 mm

Brim-object gap: 0 mm

Supports: YES

Seam position: Back