(no rubber band) FULLY PRINTABLE Otf Fidget Toy

HERE IS A FULLY REDESIGNED VERSION

USE PLA+ or TOUGH PLA 

Make sure to use the new V3 Coil! after ALOT of testing, if the coil is loose it won't function properly it must sit tightly on the blade nub

The coil direction affects its function greatly. Make sure to try both directions.

ALSO, MAKE SURE TO DEBURR AND CLEAN THE 90° ANGLES

ESPECIALLY THE BLADE SO THE SPRING LOCK CAN CATCH 

I set my Initial Layer Horizontal Expansion to -0.10 so there's less to clean, be careful setting it too low as it might affect your bed adhesion… obviously

PLA+ (recommended)
PETG (weak ah coil)

the best OTF setup I got so far is:
PLA+: Coil, Case, Lid 
PETG: Slide, Lock, Blade

I watched some videos of people installing the lid very strangely, so here's how i do it

Heavily modified inner and outer parts to make the printable coil spring work properly

Bottom ridges for improved grip and support.