Please note the license for this design! It does NOT allow for commercial use.
This is a shell to fit the original cartridge PCBs made for the Commodore 264 series of computers, i.e. the C16, C116, and the Plus/4. I tried to capture the original design while making this "redux" version as easy and quick to print as possible.
Use a 3x12mm self-tapping screw to seal the case.
See my blog post for more information.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Notes:
Print both parts with their outer side facing down on the print bed. Support is required for the label field on the top half of the case. Make sure your print bed is well leveled and your printer is not over extruding or it might be hard to remove the support material.
Category: DIY
L'auteur a marqué ce modèle comme sa propre création originale. Importé de Thingiverse.