Creality K1C Filament Holder

good

Printed in PETG. Fixed it with some screws I found only on the top and middle (I am waiting for an order of screws) but it looks like the bottom would fit aswell.

Hi,
The dimensions on my K1C is not correct. I have exactly 175mm from handler hole to the down one (along logo arm), while the model has about 173.5mm, so I have to drill both holes a bit to be able to insert screws and screw on. Besides this problem the model looks fine!

Thank you for the project!

Update: if nobody else (K1C owner) has this assembly problem than now I realized that maybe the core problem was the ABS stretching. That makes me difficult to install it without this small correction. (editado)

Quick, effortless print. Works fine. Just need small supports on the lock pin thingies, but they came of very easy. Looks great on the K1C.

Tisk ok. Děkuji 👍

I have found many designs for side spool but I found this to be the slickest looking. I recommend this design! I have printed it in Creality Carbon Fiber PLA.

need this for k1. this doesn't fit..

Printed in PETG. Attached using the three longest screws from the separate bag included in the toolbox. Don't be foolish like me and remove the protective cover BEFORE installing :D