Undead Santa

Santa ready for Xmas action!

As usually, print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. I am trying a secondary white colour to add some more tones, feel free to skip the last colour and use white from layer 26 up to the end.

Filaments Used:

• PLA Ziro Black | or any non matte black
• PLA PolyTerra Charcoal Black
• PLA Ziro Dark Gray | or Sunlu Gray
• PLA BambuLab Basic Gray
• PLA Ziro Light Gray | or Overture Light Gray
• PLA+ Esun Bone White
• PLA Overture White
• PLA Ziro Snow White

Swap Instructions:

• Start with Black
• At layer #6 (0.56mm) swap to Charcoal Black
• At layer #11 (0.96mm) swap to Dark Gray
• At layer #13 (1.12mm) swap to Gray
• At layer #20 (1.68mm) swap to Light Gray
• At layer #23 (1.92mm) swap to Bone White
• At layer #26 (2.16mm) swap to White
• At layer #32 (2.64mm) swap to Snow White for the rest.
   

Enjoy my work? Support me by joining my club. Tier 1 offers exclusive models, while Tier 2 allows you to sell my 3D printed artwork.