A good mold for a Christmas tree-shaped candle. I did two, worked really well. Here are the instructions:
1. Put the candle wick in its place.
2. Assemble the mold.
3. Tape mold tightly for leaks.
4. Pour the liquid candle wax into the mold.
5. Put it in a cold place to cool down. I put mine to freezer.
6. After its surely cold, remove the tape and heat the mold a little with a heat gun/hot water.
7. Remove the candle and cut the down piece flat.
8. Enjoy your DIY candle!
Be sure the candle is cooled down before opening the mold! Otherwise, it will break.
Fill up the mold full, heat expansion will shrink wax and look bad at the bottom. Cut off the excess.
Print with petg, pctg, abs, asa etc. I don't recommend using pla, because the wax is hot!
El autor ha marcado este modelo como su creación original.