Jagermeister alcohol funnel

The perfect Jagermeister funnel for slow and stable pouring of your favourite alcohol drinks. Especially Jager.
5h 10m
1× archivo de impresión
0.15 mm
0.40 mm
30.00 g
93
466
3
3508
actualizado 9 de junio de 2023

Descripción

PDF

This stylized funnel provides good control of the flowing liquid. I was inspired by similar funnel in Germany. This model is a remix.

I recommend supports only for antlers and bottom of the mouth, the inside of the model does not need any supports, 15% infill.

Printed best with PLA prusament

How to assemble:
You will need a conventional funnel with a diameter of 9mm of the main tube. I also recommend funnels with small tube for air to escape the bottle.

 

Cut the main tube of the funnel to 10mm length from the start.

Insert this shorter funnel into the bottom part of the reindeer head. Be careful to place the air escape tube into a small cut-out section to allow the air to flow like shown on the picture.

Now enjoy Qualitätskontrolle, Cheers!

 

Etiquetas



Origen del modelo

El autor ha hecho un remix de este modelo.

Reindeer Ornament
por p3dt
El modelo original se cambió a borrador o se eliminó

Licencia


Modelos destacados del creador

Ver más